Tuesday, September 28, 2010

DIY Embellished Shoulder Top

Turning a plain tee into an embellished one using custom shoulder pads...

...with embroidered sequins and beads.

Step 1&2: Measure the length you want the shoulder pad to be on the front of your top. Ply a sheet of paper in two. Draw the outline of the shoulder pad and cut.

Step 3: Using your stencil, trace another similar shape on a sketch pad (Keep your stencil for later use*). Roughly sketch the design you want to create with your sequins& beads. This will be your reference.

Step 4: Transfer your design on your fabric (There are several methods, you can trace your design on tracing paper and simply pin it to the fabric, or use carbon paper or use a 4b pencil like I did to mark out the lines where to sew).

Step 5: Patiently sew on the sequins and beads. It took me 10 hours to complete both! But it could have been done in less, depending on the kind of sequins you use(if it comes already threaded or not) and the way of stitching(I double stitched each bead!) ..and how quick you are of course. I included pictures of some of the various methods.

1) Sew a bead on top of a sequin to hold it in place

2) Sew in between threaded beads

3) Sew one bead at a time

4) Sew one sequin at a time making sure each overlaps the other

5) Sew threaded sequins
(Via Marshall Cavendish 'The Complete Encyclopedia of Crafts')

Step 6: Cut out the shapes leaving a 1cm seam allowance, to which you snip small V shapes.

Step 7: Using the *stencil, cut out two other similar pieces (for the back of each shoulder pads). With the right sides facing each other, pin and tack. Machine sew, but leave an opening big enough for you to flip them inside out. You will hand stitch them closed.

Step 8: Iron on reverse to flatten the pads before pinning them into place. Then hand stitch for them to stay put.

VoilĂ !

What I learned along the way: I would use a lighter fabric to make the reverse sides of the shoulder pads, just so it isn't too thick.

1 comment: